3 Valves Under Kitchen Sink

The hot and cold water supply under the sink is turned off at the valves.

3 valves under kitchen sink.

I have the faucet installed in the sink but not connected to the hot and cold water. Open the faucet to drain the line. With a few household tool. Replacing a shut off valve compression valve or angle stop may seem like a daunting task but it really takes less than 5 minutes.

Deburr the pipe with a deburring tool. For pricing and availability. Once the stop valves are installed thread the 1 2 in. Place a bucket under the old valve.

Monster master brass angle stop valve shut off quarter turn water sink bathroom toilet kitchen shower plumbing 5 8 od. Cut the supply line with a pipe cutter leaving enough room between the escutcheon plate and the cut to allow installation of the valve fitting. Sharkbite brass 1 2 in compression x 3 8 in od compression quarter turn. Keeney brass 1 2 in compression x 3 8 in compression quarter turn angle valve.

When cutting the supply line cut slowly and gently so. Straight stop valves are typically found when the water supply pipe comes up from below the. My water supply valve under the kitchen sink leaks. Plumbers conform to this standard whether installing copper.

The included pex coils can be cut to the exact length needed so there is no excess supply line to coil up under the sink providing a clean tangle free look. Types of under sink shutoff valves straight shutoff valve. The inlet must match the supply pipe and it can be a 1 2 inch female pipe thread fpt connector for galvanized pipes a 1 2 inch compression or sweat connector for. The cold water supply line from the wall is dripping water slowly.

I am replacing the faucet in my kitchen. The pipe stub outs under your sink are branch pipes that connect to 3 4 inch main pipes and they always have a diameter of 1 2 inch. Turn off the next valve up the line which may be the main water supply valve. Faucet connectors onto the faucet connections and then measure and cut the pex and push into the outlet on the stop valve and the.

Angle stop valves are normally used when the water line comes out from the wall and the outlet side of.